Qlogic Fibre Channel Switch Event Message Manual page 34

3 – Event Messages
Critical Events
(C) (8400.0030) (Switch) (Zoning edit session has been preempted by a zoning merge)
Meaning:
(C) (8400.003C) (Switch) (Network setup is changing - may lose connection - admin being
released automatically)
Meaning:
(C) (8400.0042) (Switch) (Warning - deleting the active zoneset may cause fabric isolation)
Meaning:
(C) (8400.0043) (Switch) (Warning - clearing the active zoneset may cause fabric isolation)
Meaning:
(C) (8400.0045) (Switch) (Upgrading License for 4G capability)
Meaning:
(C) (8400.0047) (Switch) (New licenses are being installed
Meaning:
(C) (8400.0049) (Switch) (The Configuration Wizard from ip_address is exiting - switch
configuration may have changed)
Meaning:
(C) (8400.004B) (Switch) (Attempted to license modes on an unsupport switch type)
Meaning:
(C) (8400.0050) (Switch) (Upgrading License allowing manufacturing setup mode
capability)
Meaning:
(C) (8400.0052) (Switch) (Upgrading License for EFCM capability)
Meaning:
(C) (8400.0053) (Switch) (The switch WWN is being upgraded)
Meaning:
3-22
A zoning edit session has been preempted by a zone merge. The
zoning edit session has been canceled.
Changes have been made to the network configuration which may
interrupt your connection to the switch.
Deleting the active zone set from the zoning database could isolate
all switches in the fabric.
Clearing all zoning definitions from the active zone set could isolate
all switches in the fabric.
Installation of the license key that grants 4-Gbps transmission
speed capability to the Fibre Channel ports is in progress.
New licenses are being installed.
Changes have been made to switch that may result in loss of
communication with the switch.
An attempt was made to install a license key for a feature that is
not supported on the switch.
The license upgrade was successful.
The license upgrade was successful.
The license upgrade was successful.
A
59060-01 B