Qlogic Fibre Channel Switch Event Message Manual page 19

A
(A1003.003C) (Incompatible Zoning mode, Isolating link)
Meaning:
Action:
(A1003.0040) (Zone Member type
Meaning:
Action:
(A1003.0041) (Zoning objects which contain Fibre Channel (FC) Address Members not
being sent to remote switch on save, not supported in this mode)
Meaning:
Action:
(A1003.0048) (Active Zone Set
set if not already in progress (the save will be deferred until zone set no
longer active!)
Meaning:
Action:
(A1003.0055) (Problem on zoning save of following switches:
Meaning:
Action:
(A1004.0001) (Port in active hard zone, but not installed or present on this switch.)
Meaning:
Action:
59060-01 B
The fabric contains switches with a mix of interoperability mode
settings.
Configure all switches in the fabric to have the same value for
interoperability mode.
member_type
An invalid zone member type was discovered in a zone. ACL hard
zone membership must be defined by domain_ID and port number.
Correct the member type.
An attempt was made to assign a zone member by FC address
while Interop mode was disabled. When Interop mode is disabled,
zone membership must be defined by world wide name or
domain_ID and port number.
Enable Interop mode or change the zone membership type.
no longer in database, please deactivate zone
zone_name
The switch will not allow you to delete a zone set from the zoning
database that has the same name as the active zone set.
Deactivate the active zone set before deleting the zone set from
the zoning database that has the same name as the active zone
set.
A zoning save was not able to be performed on some remote
switches.
Examine the named switches for obvious problems, otherwise
contact your authorized maintenance provider.
A zone member in an ACL zone on this switch is defined with an
invalid port number.
Examine the fabric and correct the zone membership.
unsupported.)
domain_ID_list
3 – Event Messages
Alarm Events
)
3-7