Qlogic Fibre Channel Switch Event Message Manual page 24

3 – Event Messages
Alarm Events
(A1005.000E) (Configuration error, can't extend credit on loop capable ports. Extended
credit not granted for port:
Meaning:
Action:
(A1005.0013) (Hotswap procedure failed - must hardreset switch)
Meaning:
Action:
(A1005.0020) (Warning - development logging is enabled)
Meaning:
Action:
(A1005.0022) (Blade in slot
AdminState)
Meaning:
Action:
(A1005.0024) (Switch must be reset after leaving the Diagnostics Admin State)
Meaning:
Action:
(A1005.0036) (Hotswap procedure failed before last reset - must hardreset switch)
Meaning:
Meaning:
(A1005.0037) (Hotswap procedure never completed - the blade will not be functional until
the switch is hardreset)
Meaning:
Action:
(A1005.0039) (Fabric Login (FLOGI) from address
Meaning:
Action:
3-12
port_number
Loop ports cannot borrow credits from the credit pool.
Change the port type to G_Port or F_Port.
The blade hot-swap procedure failed or the procedure was not
followed correctly.
Perform a hard reset.
Development logging is enabled.
Contact your authorized maintenance provider.
must be reset after leaving Diagnostics
slot_number
After changing the switch administrative state from Diagnostics to
any other state, the blade must be reset to complete the state
change.
Reset the blade.
After changing the switch administrative state from Diagnostics to
any other state, the switch must be reset to complete the state
change.
Reset the switch.
The blade hotswap procedure failed and the switch was reset
without a power-on self test.
Reset the switch with a hard reset.
The blade hot-swap procedure was not completed.
Reset the switch with a hard reset.
The payload of the FLOGI was not valid.
Check device connection or replace the device. If the problem
persists, contact your authorized maintenance provider.
)
failed)
FC_address
A
59060-01 B