Qlogic Fibre Channel Switch Event Message Manual page 36

3 – Event Messages
Critical Events
(C) (8700.0007) (EPort) (Port:
Control List (ACL) hard zone (src address =
FC_address
Meaning:
(C) (8700.000D) (EPort) (Port:
value has been reconfigured.)
Meaning:
(C) (8700.000E) (EPort) (Port:
resetting port.)
Meaning:
(C) (8700.000F) (EPort) (Port:
disabled, discarding broadcast frames.)
Meaning:
(C) (8700.0010) (EPort) (Port:
held back until ISL up time is 5 seconds)
Meaning:
(C) (8700.0011) (Eport) (Port:
compatible)
Meaning:
(C) (8700.0012) (Eport) (Port:
switches)
Meaning:
(C) (8F00.000C) From SANsurfer Switch Manager: Fabric Status
Meaning:
(C) (8F00.000D) From SANsurfer Switch Manager: Switch Status
Meaning:
3-24
) (Received frame from address not in Access
port_number
))
The destination for the receive frame is in an ACL zone and the
source is not. The frame will not be forwarded.
) (Resetting Inter-Switch Link (ISL), a time out
port_number
The Resource Allocation (R_A_TOV) or Error Detect (E_D_TOV)
timeout value has been reconfigured. E_Ports will be automatically
reset to inform the neighbor switch of the change.
) (InteropCredit value was reconfigured,
port_number
The InteropCredit parameter has changed. The affected port will
be automatically reset.
) (Broadcast frame received & broadcast
port_number
Broadcast is disabled and the switch has received a broadcast
frame. Enable broadcast to receive broadcast frames.
) (Inter-Switch Link (ISL) unstable. ISL init will be
port_number
The ISL is unstable indicating that the media module or the cable is
bad.
) (Connection failure, remote switch not
port_number
The remote switch is not compatible with the local switch. The
E_Port cannot exchange switch capabilities with the remote switch.
) (Connection failure, fabric limited to two
port_number
The switch cannot be connected to the fabric due to a license
restriction.
The severity of the fabric status has changed. The description field
will show the reason for fabric status.
The severity of the switch status has changed. The description field
will show the reason for the switch status.
, dest address =
FC_address
status
status
A
59060-01 B