Qlogic Fibre Channel Switch Event Message Manual page 29

A
(A3002.0001) (
sensor name
Meaning:
Action:
(A3002.0002) (Temp sensor
CLEARED)
Meaning:
Action:
(A3003.0001) (Fatal hardware error detected. The switch is not operational. Use 'show
post log' for more info)
Meaning:
Action:
(A3003.0002) (POST detected a fatal error the last time it ran. The switch is not
operational. Use 'show post log' for more info)
Meaning:
Action:
(A3003.0003) (Diagnostics have detected a fatal error on the I/O blade in slot
The blade is not operational.)
Meaning:
Action:
(A3004.0001) (Non-fatal hardware error detected. Use 'show post log' for more info)
Meaning:
Action:
(A3004.0002) (Diagnostics have detected a partial failure on the I/O blade in slot
slot_number
Meaning:
Action:
59060-01 B
sensor has returned to normal range - ALARM CLEARED)
The chassis temperature has returned to the normal range and the
alarm condition has been cleared.
None
on blade
sensor_name
The named blade has returned to the normal operating
temperature range.
None.
A fatal hardware error was discovered during the
Power-On-Self-Test (POST) phase of startup. This switch is not
currently operational.
Enter the Show Post Log command to investigate.
A fatal hardware error was discovered from the previous
Power-On-Self-Test (POST). This switch is not currently
operational.
Enter the Show Post Log command to investigate.
Diagnostic testing has determined that there is a failure on
specified I/O blade. The blade did not pass the Power-On-Self-Test
(POST).
Enter the Show Post Log command to investigate.
A non-fatal hardware error was discovered during the
Power-On-Self-Test (POST) phase of startup.
Enter the Show Post Log command to investigate.
)
Diagnostic testing has determined that there is a partial failure on
specified I/O blade. Most likely, at least one of the ports did not
pass the Power-On-Self-Test (POST).
Enter the Show Post Log command to investigate.
reads
slot_number value
3 – Event Messages
Alarm Events
C - ALARM
.
slot_number
3-17