Qlogic Fibre Channel Switch Event Message Manual page 15

A
(A1003.0014) (Segmenting, alias
Meaning:
Action:
(A1003.0015) (Zoneset Activation received from switch with domain
unknown zoneset
Meaning:
Action:
(A1003.0017) (Activation of zoneset by management server failed due to port
out of range.)
Meaning:
Action:
(A1003.0018) (Hard zone
Zone.)
Meaning:
Action:
(A1003.001B) (Failing remote zoning configuration, total zoneset limit would be exceeded)
Meaning:
Action:
(A1003.001C) (Failing remote zoning configuration, total member limit would be exceeded)
Meaning:
Action:
59060-01 B
merge conflict)
alias_name
There is a conflict in the zoning configuration causing the
Inter-Switch Link (ISL) to isolate. Two aliases were discovered in
the local zoning database with the same name, but different
membership.
Reconcile the active zone sets so that the two aliases have
identical membership.
zone_set_name
A zone set activation received from the named switch failed
because the zone set was not in the zoning database.
Examine the named switch to verify that the zoning database is
correct.
A zone member defined by domain ID and port was received within
a management server AZSD command with a port number out of
range.
Check management server application zoning configuration to
assure zone members are properly configured.
with non Domain/Port member reverting to Soft
zone_name
An attempt was made to assign a zone member to a hard zone by
FC address or world wide name. Hard zones require that
membership be defined by domain ID and port number.
Redefine the zone member by domain ID and port number.
The maximum number of zone sets has been exceeded on the
switch as a result of a zone merge.
Reduce the number of zone sets on the remote switch.
The maximum number of zone members has been exceeded on
the switch due to a zone merge.
Reduce the number of zone members on the remote switch.
)
3 – Event Messages
Alarm Events
failed,
domain_ID
port_number
3-3