Configuring The Event Log; Archiving And Downloading The Event Log - Qlogic Fibre Channel Switch Event Message Manual

A
2.4

Configuring the Event Log

You can customize what events that are recorded in the switch event log using the
Set Log command. With the Set Log command, you can filter the events to be
recorded by component, specific ports, and severity level. You can choose from
the following component events:
E_Port events
Management server events
Name server events
Port events
Switch management events
Simple Network Management Protocol (SNMP) events
Zoning events
Refer to the Installation Guide for your switch for more information about the Set
Log command.
2.5

Archiving and Downloading the Event Log

You can use the command line interface to create a file on the switch that contains
the most recent 200 entries plus the previous 1000 entries. This file can then be
downloaded to the workstation using FTP. To create and download a log file, do
the following:
1. Log into the switch through Telnet and create an archive of the event log.
The Set Log Archive command creates a file on the switch named logfile.
QLogic
QLogic (admin) #> set log archive
2. Open an FTP session on the switch and login with the account name images
and password images. Transfer the file logfile in binary mode with the Get
command.
59060-01 B
#> admin start
>ftp ip_address
user:images
password: images
ftp>bin
ftp>get logfile
xxxxx bytes sent in xx secs.
ftp>quit
2 – Events and Event Logging
Configuring the Event Log
2-3