Qlogic Fibre Channel Switch Event Message Manual page 32

3 – Event Messages
Critical Events
(C) (8400.0005) (Switch) (The switch is now performing a hotreset)
Meaning:
(C) (8400.0006) (Switch) (Admin mode for user
user_name
Meaning:
(C) (8400.0008) (Switch) (The switch will be reset in several seconds
Meaning:
(C) (8400.0009) (Switch) (The switch will hardreset in several seconds)
Meaning:
(C) (8400.000A) (Switch) (The switch will hotreset in several seconds)
Meaning:
(C) (8400.000B) (Switch) (The switch will be shutdown several seconds)
Meaning:
(C) (8400.000C) (Switch) (Configuration is being restored - this could take several minutes)
Meaning:
(C) (8400.000E) (Switch) (Upgrading Licensed Ports to
Meaning:
(C) (8400.000F) (Switch) (Attempted Licensed Port upgrade of ports that are already
licensed)
Meaning:
(C) (8400.0011) (Switch) (The switch will be reset in several seconds due to a config
restore)
Meaning:
(C) (8400.0012) (Switch) (I/O blade in slot
Meaning:
(C) (8400.0014) (Switch) (I/O blade in slot
Meaning:
3-20
Hot reset is in progress.
)
Admin authority mode was canceled by another user interface
session that had the authority to do so.
The switch is being reset as a result of a command from a user
interface.
A hard reset of the switch is pending.
A hot reset is pending.
The switch will be shutdown several seconds.
When a complete configuration restore is done on a switch, a
switch reset follows immediately to place the new configuration in
effect.
The number of licensed ports on the switch has been upgraded.
The switch has already been upgraded to the number of licensed
ports.
Switch management is processing a config restore command.
slot_number
An I/O blade has been inserted into the chassis.
slot_number
An I/O blade has been removed from the chassis.
was canceled by user
user_name
number_of_ports
has been inserted into chassis)
has been removed from chassis)
A
)
59060-01 B