Qlogic Fibre Channel Switch Event Message Manual page 35

A
(C) (8600.0009) (PortApp) (Port:
port_number
Meaning:
(C) (8600.000A) (PortApp) (Port:
port_number
Meaning:
(C) (8600.000B) (PortApp) (Port:
port_number
Meaning:
(C) (8600.0013) (PortApp) (Port:
invalid vendor data from media device for port
Meaning:
(C) (8600.0015) (PortApp) (Port:
port_number
Meaning:
(C) (8600.0016) (PortApp) (Online port(s)
hot reset.)
Meaning:
(C) (8600.0017) (PortApp) (External port license count exceeded, downing external port
port_number
Meaning:
(C) (8600.0018) (PortApp) (External port license became available, re-starting downed
external ports)
Meaning:
59060-01 B
) (Link reset (LR) to be performed on port
port_number
.)
The port will perform a link reset (LR) due to loss of credit issue.
) (Link reset (LR) to be performed on port
port_number
.)
The port will perform a link reset (LR) due to loss of credit issue.
) (Link reset (LR) to be performed on port
port_number
.)
The port will perform a link reset (LR) due to loss of credit issue.
) (EV_MEDIA_ID_FAULT event received
port_number
The switch could not read and verify the media module ID. This
may indicate a discovery error or a bad checksum in the serial ID.
Other possibilities include an improperly installed media module or
an internal media I/O hardware fault.
) (Unresponsive device
port_number
removed from the fabric.)
A device on the loop port did not take a OPN off the loop destined
for it. This suggests either the device has been physically removed
or is faulty. It has been removed from \the fabric nameserver.
port_numbers
Some ports were disrupted during hot reset operation due to
events causing disruption.
)
The named external port is down because the number of licensed
external ports has been exceeded.
An external port that was previously down because of insufficient
port licenses is now online.
3 – Event Messages
)
port_number
device_al_pa
were reset due to disruption during
Critical Events
on port
3-23