Qlogic Fibre Channel Switch Event Message Manual page 14

3 – Event Messages
Alarm Events
(A1003.000B) (Failing release of fabric lock held by switch with domain
Meaning:
Action:
(A1003.000C) (Fabric Busy, failing lock request from domain
Meaning:
Action:
(A1003.0010) (Segmenting, zoneset
Meaning:
Action:
(A1003.0011) (Segmenting, zoneset
Meaning:
Action:
(A1003.0012) (Segmenting, zoneset
Meaning:
Action:
(A1003.0013) (Segmenting, zone
Meaning:
Action:
3-2
The local switch is locked as the result of zoning changes being
made by a remote switch.
Wait for the lock to time out and try again.
The command failed because the fabric is busy with another
command in progress.
Retry the command in 10 seconds.
zone_set_name
In non-interop mode, there is a conflict in the zoning configuration,
causing the Inter-Switch Link (ISL) to isolate. The zone set is not
found within the local zoning data base while interop mode is
disabled.
Contact your authorized maintenance provider.
zone_set_name
In non-interop mode, there is a conflict in the zoning configuration,
causing the Inter-Switch Link (ISL) to isolate. A switch tried to
activate a zone set that is already active while interop mode is
disabled.
Contact your authorized maintenance provider.
zone_set_name
In non-interop mode, there is a conflict in the zoning configuration,
causing the Inter-Switch Link (ISL) to isolate. After a zone merge
with interop mode disabled, two zone sets were discovered in the
local zoning database with the same name, but different
membership.
Contact your authorized maintenance provider.
merge conflict)
zone_name
In non-interop mode, there is a conflict in the zoning configuration,
causing the Inter-Switch Link (ISL) to isolate. After a zone merge
with interop mode disabled, two zone were discovered in the local
zoning database with the same name, but different membership.
Contact your authorized maintenance provider.
domain_ID
not defined)
already active)
merge conflict)
A
)
domain_ID
)
59060-01 B