Qlogic Fibre Channel Switch Event Message Manual page 41

A
(I) (8200.0202) (mserver) (Rejecting request (GZS) for zone set
unsupported alias member(s))
Meaning:
(I) (8200.0300) (mserver) (Cannot register HBA World Wide Name (WWN)
FDMI database has reached its configured limit.)
Meaning:
(I) (8200.0301) (mserver) (Port:
FC_address
Meaning:
(I) (8300.0004) (zoning) (New Active ZoneSet
Meaning:
(I) (8300.0007) (zoning) (Fabric lock held by domain
Meaning:
(I) (8300.0008) (zoning) (Processing zoning requests, Checkpoint not permitted)
Meaning:
(I) (8300.0009) (Zoning) (Reading zoning database, Checkpoint not permitted)
Meaning:
(I) (8300.0010) (Zoning) (Removing all inactive zoning objects)
Meaning:
(I) (8400.0001) (Switch) (Modifying configured DomainID
domain_ID
Meaning:
59060-01 B
The fabric zone server command GZS (Get Zone Set) was rejected
because the requested zone set contains one or more members
that are aliases. Since aliases are not defined in GS-3, the request
could not be completed.
The switch contains a database that is configured to allow a certain
number of HBAs to register Fabric Device Management Interface
(FDMI) information with this switch. An HBA has attempted to
register its FDMI information with the switch, but allowing it to do so
would cause the FDMI database to exceed the configured limit.
) (Rejecting FDMI request from address
port_number
on port
port_number
The Fabric Device Management Interface (FDMI) server on this
switch has been configured disabled so any FDMI requests
received by the switch will be rejected.
A new zone set has been activated.
Another switch has acquired our fabric zoning lock. Zoning request
is about to occur. Retry hotreset after fabric zoning lock is released.
Another switch has acquired our fabric zoning lock. Zoning request
is about to occur. Retry hotreset after fabric zoning lock is released.
A change to the fabric zoning data base forced a read of the data
base to occur. Retry hotreset after read is complete
All zones that were members of the previously active zone set are
being removed from the zoning database.
)
The configuration is changing. The configured domain ID is
changed to the negotiated value.
zone_set_name
; FDMI is configured as disabled.)
)
zone_set_name
, hotreset not permitted)
domain_ID
domain_ID
3 – Event Messages
Informative Events
containing
,
device_WWN
to negotiated value
3-29