Qlogic Fibre Channel Switch Event Message Manual page 17

A
(A1003.002D) (Zone Merge response indicates failure to merge, Isolating link)
Meaning:
Action:
(A1003.002F) (SW2 Zoning Not Supported by other switch, Isolating link)
Meaning:
Action:
(A1003.002E) (Zoning merge has been rejected.)
Meaning:
Action:
(A1003.0031) (Error reading zoneset from activate direct.)
Meaning:
Action:
(A1003.0032) (Zoneset
zone/alias))
Meaning:
Action:
(A1003.0033) (No memory for command completion)
Meaning:
Action:
(A1003.0034) (Merge failed, total zoneset limit would be exceeded.)
Meaning:
Action:
59060-01 B
The attempt to merge two fabrics failed because each active zone
set contained a zone with the same name, but different
membership.
Edit the affected zone to remove the conflict or deactivate one of
the zone sets.
The inter-switch link isolated because the local switch is configured
for FC-SW-2 compliant zoning (interoperability mode set to
Standard), but the remote switch is not.
Set the interoperability mode on the remote switch to Standard.
The attempt to merge two fabrics failed because each active zone
set contained a zone with the same name, but different
membership.
Edit the affected zone to remove the conflict or deactivate one of
the zone sets.
A device supporting management server has sent an Activate
Zoneset Direct $(AZSD) command that did not follow the expected
standard layout.
Contact your authorized maintenance provider.
failed validity checks (empty or contains empty
zone_set_name
The zone set either has no zones or contains a zone or alias
without members.
Add zones and members, or remove the empty zones and aliases
from the zone set.
Insufficient switch memory.
Contact your authorized maintenance provider.
A fabric merge failed because the combined number of zone sets
exceeds the zoning database limit.
Remove zone sets from the local switch zoning database to allow
fabric merge to complete.
3 – Event Messages
Alarm Events
3-5