Qlogic Fibre Channel Switch Event Message Manual page 25

A
(A1005.003A) (Fabric Login (FLOGI) from address
authorization/authentication)
Meaning:
Action:
(A1005.003B) (Warning - Debug logging filter level is set)
Meaning:
Action:
(A1005.003C) (User Port(s)
to state DOWNED.)
Meaning:
Action:
(A1005.003E) (Warning, port(s)
NDCLA.)
Meaning:
Action:
(A1005.003F) (Badly formatted SML Notification Ack session
Meaning:
Action:
(A1005.0040) (Setting port admin state DOWN due to POST failure)
Meaning:
Action:
(A1005.0042) (Not enforcing security on loop port
Meaning:
Action:
59060-01 B
Security authentication failed.
Check security configuration on both the device and the switch to
ensure they are configured properly.
Debug logging has been set using the Set Log Level command.
Confirm that you intended to do this. If not, use the Set Log Level
command to change the severity level to Info, Warn, or Critical.
, isolated, lost steering path, administering them
port_numbers
The ports required for steering the user ports have failed.
Contact your authorized maintenance provider.
port_numbers configured ONLINE, but remain DOWN after
Ports that were down before a non-disruptive code load and
activation remain down. This message serves as a reminder
because the alarm log is cleared during the non-disruptive code
load and activation.
None.
The switch sent a notification which was not formatted correctly,
there may be a resource problem on the switch.
If this is a recurring message, contact your authorized maintenance
provider.
The port failed the power-on self test and has been disabled.
Contact your authorized maintenance provider.
A device that supports security logged in to the switch as a loop
device. The switch does not enforce security on loop ports.
None.
failed
FC_address
session_ID
for device
port_number
3 – Event Messages
Alarm Events
string - )
string
.)
device_WWN
3-13