Icu - Intergraph TD-22x System Manual

7. After installing the ICU on the hard disk drive, remove the remaining diskette from the
floppy disk drive.
8. Insert the ICU boot diskette into the floppy disk drive.
9. Restart the system.
10. At the command prompt, change to the ICU directory (for example,
and key in icu.
TD-220 ICU
To create ICU diskettes:
1. From the IBBS login, go to Intergraph Product Centers, Systems and Networking, File
Libraries, and Delivered Drivers; select the operating system and hardware platform.
2. Find the
3. Use an unzip utility to open the
4. Insert a 3.5-inch high-density diskette into the floppy disk drive.
5. In the directory containing the
creates two ICU diskettes, one of which is a boot diskette. Label the first diskette ICU
Diskette 1, and label the second diskette ICU Diskette 2.
6. After the
floppy disk drive.
NOTE On a system running Windows NT and using the NT File System (NTFS), you must install
the ICU to a File Allocation Table (FAT) partition on your system's hard disk drive. ICU
installation will not work on an NTFS-only system because you cannot access NTFS
partitions from the ICU boot diskette. You should create a 10 MB FAT partition to allow for
future growth of the ICU and its information database.
To install and run the ICU:
1. Insert ICU diskette 1 into the floppy disk drive.
2. Restart the system.
3. At the command prompt, key in install.
4. Follow the prompts to install the ICU to a FAT partition on the hard disk drive.
5. After installing the ICU on the hard disk drive, remove the remaining diskette from the
floppy disk drive.
6. Insert ICU diskette 1 into the floppy disk drive.
7. Restart the system.
product and download it to a directory on your system.
SYSUTIL
SYSUTIL
SYSUTIL
. program completes, remove the remaining diskette from the
INSTALL BAT
product and extract the files from it.
files, run the .
INSTALL BAT
55
:\ \ )
C PLUGPLAY

ICU

program. This