Table of Contents

Advertisement

36
TD-20 ICU
To create ICU diskettes:
1.
From the IBBS login, go to Intergraph Product Centers, Systems and Networking, File
Libraries, and Delivered Drivers; select the operating system and hardware platform.
2.
Find the
3.
Use an unzip utility to open the
4.
Insert a 3.5-inch high-density diskette into the floppy disk drive.
5.
In the directory containing the
boot diskette and two ICU diskettes. Change out diskettes as needed, numbering them 1
through 3 as you remove them to keep them in order.
6.
After the
disk drive. Label the boot diskette ICU Boot Diskette; label the second diskette ICU
Diskette 1; and label the third diskette ICU Diskette 2.
NOTE
On a system running Windows NT and using the NT File System (NTFS), you must install the
ICU to a File Allocation Table (FAT) partition on your system's hard disk drive. ICU installation
will not work on an NTFS-only system because you cannot access NTFS partitions from the
ICU boot diskette. Intergraph recommends creating a 10 MB FAT partition to allow for future
growth of the ICU and its information database.
To install and run the ICU:
1.
Insert the ICU boot diskette into the floppy disk drive.
2.
Restart the system.
3.
After the system has restarted, replace the ICU boot diskette in the floppy disk drive with
ICU diskette 1.
4.
At the command prompt, key in install.
5.
Since the floppy disk drive (usually drive A) is not a fixed disk, you are prompted to enter
your boot drive again. Key in the drive letter representing a FAT partition on your
system's hard disk drive.
6.
Follow the prompts to install the ICU to the FAT partition on the hard disk drive.
7.
After installing the ICU on the hard disk drive, remove the remaining diskette from the
floppy disk drive.
8.
Insert the ICU boot diskette into the floppy disk drive.
9.
Restart the system.
10. At the command prompt, change to the ICU directory (for example,
and key in icu.
product and download it to a directory on your system.
SYSUTIL
SYSUTIL
SYSUTIL
.
program completes, remove the remaining diskette from the floppy
INSTALL
BAT
product and extract the files from it.
files, run the
.
INSTALL
BAT
program. This creates a
:\
\
)
C
PLUGPLAY

ICU

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TD-20 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Td-200

Table of Contents