Td-225 Bios - Intergraph TD-22x System Manual

26

TD-225 BIOS

To update the TD-225 BIOS:
1. Record the BIOS parameter settings for your system. To do this, restart the system, and
press the
parameter, then exit from BIOS Setup and let the system continue to boot.
2. From the IBBS login, go to Intergraph Product Centers, Systems and Networking, File
Libraries, and Delivered Drivers; select the operating system and hardware platform.
3. Find the
4. Use an unzip utility to open the
5. Insert a blank, formatted diskette into the floppy disk drive.
6. In the directory containing the
creates a boot diskette with the new BIOS file and the BIOS flash programming utility.
7. After the
restart the system.
8. At the MS-DOS command prompt, run
example, if the BIOS file on the boot diskette is named
following command to update the BIOS:
amiflash amiboot.rom
9. After the BIOS is updated, you are prompted to press a key to restart the system.
Remove the diskette from the floppy disk drive and label it BIOS Update date, where
date is today's date.
Press a key to restart the system. As the system boots, press
like the following:
CMOS settings are corrupt
Press <F1> to continue.
10. Make sure that all parameter settings match the settings you recorded before you
updated the BIOS. In particular, verify that on both the Main/Primary Master and
Main/Primary Slave screens, both LBA Mode Control and 32 Bit I/O are set to
Enabled.
key during boot to run BIOS Setup. Write down the setting for each
DELETE
225 product and download it to a directory on your system.
FLASHTD
FLASHTD
FLASHTD
. program completes, leave the diskette in the floppy disk drive and
INSTALL BAT
225 product and extract the files from it.
225 files, run the
INSTALL
to update the current BIOS. For
AMIFLASH
AMIBOOT
F1
. program. This
BAT
. , key in the
ROM
when you see a message