Installing The Ensoniq Sound Processor Driver - Intergraph TD-22x System Manual

u
Configure the system as described in Chapter 3, "Configuring the System."
u
If your system was running Windows NT 4.0 Service Pack software, install this software
after installing drivers and other system software, and after installing any application
software products.
u
If you created a Quick-Fix Engineering (QFE) backup diskette during system
configuration, install the QFE update software. Install QFE software after installing any
Windows NT 4.0 Service Pack software. See the
for more information.
u
Perform any operational changes required for your system as described in Chapter 4,
"Operating Notes."

Installing the Ensoniq Sound Processor Driver

Systems with an audio option include an Ensoniq sound card. The Ensoniq sound card is
delivered with a software CD-ROM that contains driver software, wavetable and mixer
software, and online documentation for installing and using the sound card. However, the
online Ensoniq documentation does not describe how to install the software on a system
running Windows NT 4.0 -- for example, if you must reinstall the operating system, or if you
add a system audio option.
To install the Ensoniq driver, wavetable, and mixer software:
1. Insert the Ensoniq software CD-ROM into the system's CD-ROM drive.
2. From the Start menu, go to Settings/Control Panel/Multimedia/Devices (tab); then click
Add..
3. In the Add dialog, in the List of Drivers, click Unlisted or Updated Driver; then click
OK.
4. In the Install Driver dialog, type the path to the Windows NT software on the CD-ROM;
then click OK. The Windows NT software can be found on the CD-ROM at
\winnt\language\cd, where language is the language of the operating system (for
example, english).
5. After the software has been installed, in the Add Unlisted or Updated Driver dialog,
select Ensoniq AudioPCI; then click OK.
6. When the configuration dialog displays, click OK to accept the default settings.
7. In the Multimedia Properties dialog, click OK.
8. Remove the CD-ROM from the system; then restart the system.
After you install the software, see Chapter 4, "Operating Notes," to set up quick access to
system audio through the Taskbar or the Start menu.
. file on the QFE diskette
README TXT
41