Windows 95 - Intergraph TD-22x System Manual

NOTE The QFE update software includes an updated ATAPI device driver that should be installed
after Service Pack 3.
NOTE For reasons of system performance, if a TR-4i tape drive or a Zip drive is installed, do not
enable DMA use on the IDE channel to which the drive is connected. A TR-4i tape drive or
Zip drive is usually connected to Channel 0 when installed at the factory.
2. Insert the Windows NT 4.0 Service Pack 3 CD-ROM into your system's CD-ROM drive.
3. In Explorer or File Manager, navigate to the \
4. Double-click
5. The Current DMA Usage boxes indicate which channels have IDE/ATAPI devices. For
each channel with an IDE/ATAPI device, click Enabled; then click OK.
6. Restart the system.

Windows 95

Depending on your system's configuration, you will need some or all of the following system
software during the installation process:
u
Windows 95 OSR2 Service Release 2.1
u
PIIX4 IDE patch (TD-22 and TD-25 only)
u
SCSI adapter driver
u
Video display adapter driver
u
Network adapter driver
u
Sound card driver
u
Mouse driver
When reinstalling Windows 95, you must also reinstall various system software products
during and after operating system Setup. After going through Setup, be sure you reinstall
the following important system software products, as appropriate:
u
4
PIIX W
recognize the PIIX4 controller on the TD-22 or TD-25 system board.
u
95
W SR
support for Universal Serial Bus (USB).
You can create backup diskettes for these products using InterSite Version Manager.
CAUTION On a TD-22 or TD-25, install the
Installing the patches in the incorrect order can cause the system to behave erratically.
. . The ATAPI DMA support dialog displays.
DMACHECK EXE
95 (TD-22 and TD-25 only), a software patch that enables Windows 95 to
2.1 (all systems), a supplement of Windows 95 Service Release 2.1 that includes
W
SUPPORT
95 2.1 patch before you install the
SR
\ \ 386 directory.
UTILS I
4 95 patch.
PIIX W
43