24
8. At the MS-DOS command prompt, run
example, if the BIOS file on the boot diskette is named
the following command to update the BIOS:
phlash tx_i06.rom
9. After the BIOS is updated, the system shuts down. Remove the diskette from the floppy
disk drive and label it BIOS Update date, where date is today's date.
10. Turn on power to the system.
As the system boots, press
PhoenixBIOS Version 4.0 Release 6.0 430TX-I006
BIOS Setup starts.
11. Make sure that all parameter settings match the settings you recorded before you
updated the BIOS. In particular, verify that on both the Main/Primary Master and
Main/Primary Slave screens, both LBA Mode Control and 32 Bit I/O are set to
Enabled.
12. Save and exit from BIOS Setup.
13. Restart the system.
For more information on the phlash command, type phlash /? at the command prompt. For
more information on updating the BIOS, see the
FLASHPROG
TD-220 BIOS
To update the TD-220 BIOS:
1. Record the BIOS parameter settings for your system. To do this, restart the system, and
press
then exit from BIOS Setup and let the system continue to boot.
2. From the IBBS login, go to Intergraph Product Centers, Systems and Networking, File
Libraries, and Delivered Drivers; select the operating system and hardware platform.
3. Find the
4. Use an unzip utility to open the
5. Insert a diskette into the floppy disk drive.
6. In the directory containing the
creates a boot diskette with the new BIOS file and the BIOS flash programming utility.
7. After the
restart the system.
F2
product.
during boot to run BIOS Setup. Write down the setting for each parameter;
F1
product and download it to a directory on your system.
FLASHPROG
.
program completes, leave the diskette in the floppy disk drive and
INSTALL
BAT
.
to update the current BIOS. For
PHLASH
EXE
when you see a message like the following:
README
product and extract the files from it.
FLASHPROG
files, run the
FLASHPROG
-
06.
, you would key in
TX
I
ROM
.
file delivered with the
TXT
.
program. This
INSTALL
BAT
Need help?
Do you have a question about the TD-22x and is the answer not in the manual?