Intergraph TD-22x System Manual page 49

35
3. Configure the BIOS for a SCSI system.
See Chapter 3, "Configuring the System," for BIOS configuration information. See the
appropriate System Board Manual for device connection information.
If the CD-ROM drive does not appear in the Windows NT operating system after booting
from a SCSI disk drive, make sure that the AT Attachment Packet Interface (ATAPI) device
is enabled.
To enable the ATAPI device:
1. Open Devices in the Windows NT Control Panel. The Devices dialog displays.
2. Highlight atapi in the Device list; then select Startup. The Device dialog displays.
3. Under Startup Type, select Boot; then select OK.
4. In the Devices dialog, select Close.