Loading Trays 1 And 2 - Xerox ColorQube 9303 User Manual

Trays 1 and 2

Loading Trays 1 and 2

If Tray 1 or Tray 2 is set as a Dedicated tray, the media requested must be loaded in the tray and the
settings cannot be adjusted.
CAUTION: A problem will occur if a tray is opened while it is being used to feed media. Do not
open Tray 1 if Tray 2 is open.
1. Open the tray.
2. Place the media in the tray. Media
must be positioned against the left
side of the tray.
• Load pre-printed paper and
labels face-up and with the top
towards the front of the device.
• Load hole punched paper with
the holes on the right edge.
Paper must not be loaded above the
maximum fill line.
3. Make sure that the paper guides just
touch the paper.
• To position the right side guide, squeeze the clamp mechanism and slide the guide to touch
the right edge of the media.
• To position the rear guide,
squeeze the clamp mechanism
and slide the guide to touch the
rear edge of the media.
4. Close the paper tray.
The paper settings for the tray are
displayed on the touch screen.
5. Confirm or change the settings, as
required.
240 ColorQube™ 9301/9302/9303
Paper and Media