Securing The Two Mounting Brackets - HP Surestore 64 - Director Switch Installation Manual

Figure 12: Aligning the switch in the rack
3. Loosely attach the rear angle bracket to the rack rail with the two panhead
4. Repeat
5. The two rear angle brackets now touch the outside surfaces of the rear
6. If you are certain that the hardware lines up properly, secure the hardware as
Director 2/64 Installation Guide
Phillips screws provided, as shown in
step 2 and step 3
Figure 13.
mounting plates. Slide the switch all the way into the rack to where the front
mounting bracket meets the rack rails.
follows:
a. Secure each rear mounting plate to the rear angle bracket with the two
screws provided.
b. Move to the front of the switch and secure each front mounting bracket
with the three screws provided.
Installing and Configuring the Director 2/64
Figure
for the corresponding rear angle bracket, as shown in
13.
55