Insert The Rear Cage Nuts In The Rack; Finalize The Rack Mounting Procedure; Securing Shelf Brackets - HP Surestore 64 - Director Switch Installation Manual

Installing and Configuring the Director 2/64
3. Count up 5 square openings from the cage nut you just installed, and insert the
4. Count up four square openings and install the third cage nut.
5. Repeat this procedure to install cage nuts in the corresponding front rail.

Insert the Rear Cage Nuts in the Rack

Use these steps to insert the four supplied cage nuts in the rack's rear rails:
1. Select one of the rear rails.
2. Count up six square openings from the top screw of the rear shelf bracket.
3. Count up sixteen square openings from the cage nut you just installed, and
4. Repeat this procedure to install cage nuts in the corresponding rear rail.

Finalize the Rack Mounting Procedure

Use the following sections to complete the installation procedure.
After completing the steps outlined in the previous sections, prepare to orient the
switch in the rack as follows.
1. Carefully lift the switch into the front of the rack and onto the shelf brackets
2. Align one rear angle bracket with the cage nuts installed earlier, as shown in
Note:
mounting plate.
54
next cage nut.
Insert the first of two cage nuts.
insert the next cage nut.
WARNING: The Director 2/64 weighs approximately 115 pounds. Use
proper handling and lifting equipment to reduce the possibility of injury or
product damage.
and slide the switch forward into the rack until the edge of the rear mounting
plates are approximately 1 inch from the rack's rails, as shown in
"Insert the Cage Nuts" on page 53.
Make sure that the angle bracket is in contact with the outside surface of the
Figure
Director 2/64 Installation Guide
12.