Configure Director Management Style; Configure Identification Dialog Box - HP Surestore 64 - Director Switch Installation Manual

Installing and Configuring the Director 2/64
Follow these steps to configure the director identification:
1. At the Hardware View page, choose Configure > Identification. The
Figure 40: Configure Identification dialog box
2. Click Activate to save the information and close the dialog box.

Configure Director Management Style

Note:
State from the Maintenance menu to display the Set Online State dialog box, then click
Set Offline. Be sure to set the director back online after you change this value.
Perform this procedure to set the director to open systems or FICON management
style. This setting only affects the management style used to manage the director;
it does not affect port operation. OSI devices can communicate with each other if
88
Configure Identification dialog box displays, as shown in
a. Type a director name of 24 or fewer alphanumeric characters in the Name
field. Each director should be configured with a unique name.
If the director is installed on a public LAN, the name should reflect the
director's Ethernet network DNS host name. For example, if the DNS
host name is SAN64.hp.com, the name entered in this dialog box is
SAN64.
b. Type a director description of 255 or fewer alphanumeric characters in the
Description field.
c. Type the director's physical location (255 or fewer alphanumeric
characters) in the Location field.
d. Type the name of a contact person (255 or fewer alphanumeric
characters) in the Contact field.
To change this value, you must first set the director offline. Choose Set Online
Figure 40.
Director 2/64 Installation Guide