LAN-Connect the Director
Use these steps to connect the rack mounted director to the Ethernet LAN
segment.
1. Connect one end of an Ethernet cable to the RJ-45 connector on each CTP2
1
2
Figure 35: LAN-connect the director
2. Connect the remaining end of each Ethernet cable to the LAN as directed by
Note:
interface. Attach the Ethernet LAN segment to an Internet connection and see
Chapter
Director 2/64 Installation Guide
card, as shown in
Figure
Remote workstation
Ethernet hub or switch (customer
supplied)
the customer's network administrator.
If an HAFM server is not available, use the Embedded Web Server (EWS)
3.
Installing and Configuring the Director 2/64
35.
HAFM server (laptop or rack mount)
3
Director 2/64
4
79