Configure And Enable E-Mail Notification; Configure E-Mail Dialog Box - HP Surestore 64 - Director Switch Installation Manual

Configure and Enable E-mail Notification

Use this procedure to configure and enable e-mail addresses and Simple Mail
Transfer Protocol (SMTP) server addresses to receive e-mail notification of
director (and other managed product) events. The addresses must be configured
via HAFM, then enabled. See
Use these steps to configure and enable e-mail and SMTP server addresses:
1. Open the Products View page, choose Maintenance > Configure E-Mail.
Figure 45: Configure E-Mail dialog box
2. To enable e-mail transmission of configured addresses, click Enable E-Mail
Note:
individually.
3. Click OK to save the information and close the dialog box.
4. Double-click the Director 2/64 icon. The Hardware View page for the
Director 2/64 Installation Guide
The Configure E-Mail dialog box displays, as shown in
a. Type the IP address or DNS host name of the SMTP server in the SMTP
Server field. Use 64 or fewer alphanumeric characters.
b. For the E-Mail Addresses fields, type the e-mail addresses of up to five
recipients who should be informed of system events. Use 64 or fewer
alphanumeric characters for each entry.
Event Notification. A check mark displays in the box when transmission is
enabled.
Using HAFM, enable or disable e-mail event notification for each director
selected director displays.
Installing and Configuring the Director 2/64
"Test Remote Notification" on page 109.
Figure 45.
101