Delete Alerts; Test Remote Notification - HP Surestore 64 - Director Switch Installation Manual

Delete Alerts

Use the following steps to delete existing threshold alerts.
1. At the Hardware View page, choose Configure > Threshold Alerts. The
2. Choose the alert that you want to delete by selecting the alert information in
3. Click Yes. The alert is removed from the dialog box.

Test Remote Notification

If the e-mail and one of the call-home notification features are enabled, set up the
HAFM application to test these remote notification features. Because the features
are configured at the HAFM application, call-home and e-mail notification are
enabled for multiple directors.
Note:
sections,
Call-Home
Use these steps to test remote notification:
1. Close the Hardware View page for the director by clicking Close at the
2. Choose Maintenance > Test Remote Notification. The Test Remote
Figure 53: Test Remote Notification dialog box
3. Check the Call-Home and E-Mail check boxes.
4. Click Send Test. Call-home and e-mail test messages are transmitted and an
Director 2/64 Installation Guide
Configure Threshold Alerts dialog box displays.
the table and click Delete. A message displays asking you to confirm the
deletion.
Prior to using test remote notification, complete the steps in the previous
"Configure and Enable E-mail
Features."
Navigation Control panel.
Notification dialog box displays, as shown in
Information dialog box displays.
Installing and Configuring the Director 2/64
Notification" and "Configure and Enable
Figure 53.
109