HP Surestore 64 - Director Switch Installation Manual page 74

Installing and Configuring the Director 2/64
Use the following steps to verify or change (if required) a director IP address,
subnet mask, or gateway address:
1. Remove the protective cap from the 9-pin maintenance port at the rear of the
74
— Microsoft Windows 98, Windows 2000, Windows XP, or Windows NT
4.0 operating system
— RS-232 serial communication software (for example, ProComm Plus or
HyperTerminal)
Note that the HAFM server may be used for this function and that
HyperTerminal is included in Windows 2000 provided in the HAFM server.
An asynchronous RS-232 null modem cable (supplied with the Director 2/64)
director (a flat-tip screwdriver may be required). See
1.
Figure 30
Director 2/64 Installation Guide