Configure And Enable Call-Home Features; Configure And Enable Ethernet Events; Configure Threshold Alerts - HP Surestore 64 - Director Switch Installation Manual

Installing and Configuring the Director 2/64
5. Choose Maintenance > Enable E-Mail Notification. A check mark displays

Configure and Enable Call-Home Features

There are two call-home features available, and only one is installed when the
HAFM application is installed on the HAFM server. To learn more about
configuring Call-Home features, refer to the HP StorageWorks HAFM server
installation guide.

Configure and Enable Ethernet Events

Perform this procedure to configure and enable Ethernet events. An Ethernet
event is recorded (after a user-specified time interval) when the
director-to-HAFM Server communication link drops. To configure and enable
Ethernet events:
1. Choose Maintenance > Configure Ethernet Events. The Configure
Figure 46: Configure Ethernet Events Dialog Box
2. Click the Enable Ethernet Events check box. A check mark displays in the
3. Type a value between 10 through 120 minutes in the Ethernet Timeout field.
4. Click OK to close the dialog box.

Configure Threshold Alerts

A threshold alert notifies users when the transmit (Tx) or receive (Rx) throughput
reaches specified values for specific director ports or port types, (E_Ports or
F_Ports). You are notified of a threshold alert by:
102
in the check box to indicate that e-mail notification for the director is enabled.
Ethernet Events dialog box displays, as shown in
check box to indicate Ethernet events are enabled.
A yellow triangle that displays on the port in the Port Card View.
A yellow triangle that displays on the port in the Hardware View.
A yellow triangle that displays in the Alert column of the Port List View.
Figure 46.
Director 2/64 Installation Guide