HP Surestore 64 - Director Switch Installation Manual page 105

5. Click Next. A new screen displays with additional parameters, as shown in
Note:
Figure 49: New Threshold Alerts dialog box—second screen
6. Enter a percentage from 1 through 100 for % utilization. When throughput
7. Enter the amount of cumulative minutes in which the % utilization should
8. Enter the interval in minutes in which throughput is measured and threshold
Director 2/64 Installation Guide
Tx Throughput—An alert will occur if the threshold set for transmit
throughput is reached.
Rx or Tx Throughput—An alert will occur if the threshold set for either
receive or transmit throughput is reached.
Figure 49. The name configured for the alert displays at the top of the screen.
Click Previous if you need to return to the previous screen.
reaches this percentage of port capacity, a threshold alert will occur.
exist during the notification interval before an alert is generated. You can also
choose At any time if you want an alert to occur whenever the set %
utilization is reached. The valid range is from 1 to the interval value set in
step 8.
notifications can occur. The valid range is 5 minutes to 70,560 minutes.
Installing and Configuring the Director 2/64
105