Common Thresholds; Range Threshold - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Email Alert Troubleshooting
1. Enter the
2. Add the switch hostname and IPaddress to Yellow Pages (YP) table/ DNS
3. Use the
4. Use
5. Check recipient address by using
6. To verify e-mail alert, use the
7. Enter the
Note:
For more information, refer to

Common Thresholds

The distinct thresholds in this section serve as identifiers for series of boundaries.
The thresholds in this section are not options that you can choose in Fabric Watch.
Instead, you can configure Fabric Watch to serve in specific ways that appear here.
For information on how to configure the thresholds in this section, refer to the
Using chapters in this book.

Range Threshold

A range threshold consists of a high and low boundary. All values between these
boundaries form a "normal region." When a counter crosses the boundary, that
occurrence registers an event.
Counters may oscillate around the upper or lower boundary of a range threshold
and, as a result, cause numerous events in a short period of time. To reduce the
number of events that occur as counters move from beyond a boundary to within a
Fabric Watch Version 3.1.x/4.1.x User Guide
hostname command
command (Core Switch 2/64; set for both CP0 and CP1) to set the hostname
and verify that you have set it correctly. Do not configure the hostname to be
identical to the switchname.
(Domain Name Server).
dnsconfig
IPaddress, and to check if the Domain Name and Name Server are configured
properly.
to set the recipient e-mail address for any one class and also
fwmailcfg
enable it.
number.
configured class.
fwalarmsfiltershow
alarm is on.
Alarms will only occur after you configure the fwalarmsfilterset command to 1.
(SAN Switch 2/32) or
command to set domain name and Name Server
fwMailCfg
fwMailCfg
command to verify that the Fabric Watch
fwalarmsfilterset on page 180.
Using Fabric Watch
ippaddrset
command option 1 and class
command option 4 then the
47