Protocol Error Area Messages; Probable Cause; Recommended Action - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Responding to Fabric Watch Messages
Description
Troubleshooting
Message
Description
Troubleshooting
Message
Description
Troubleshooting

Protocol Error Area Messages

Probable Cause

Occasional protocol errors occur due to software glitches. Persistent protocol
errors occur due to hardware problems.

Recommended Action

Check both ends of your connection, and verify that your cable and SFP are not
faulty.
130
Explains that the number of signal losses per minute has fallen to a value
below the low boundary. Provides the new value.
This message is informational. Respond to this message as is appropriate to
the particular policy of the end-user installation.
WARNING EXCEEDED, 3, portSignal<element index> (Port Loss of
Signal <element index>) is exceeded boundary. current value : <value>
Error(s)/minute. (info)
Explains that the number of signal losses per minute has risen above or
fallen below the acceptable range. Provides the new value.
This message is informational. Respond to this message as is appropriate to
the particular policy of the end-user installation.
FW-INBETWEEN, 3, portSignal<element index> (Port Loss of Signal
<element index>) is between high & low boundaries. current value :
<value> Error(s)/minute. (info)
Explains that the number of signal losses per minute has changed from a
value outside of the acceptable range to a value within the acceptable range.
Provides the new value.
This message is informational. Respond to this message as is appropriate to
the particular policy of the end-user installation.
Fabric Watch Version 3.1.x/4.1.x User Guide