Processor Board (Msmt329) - Intergraph InterServe 8000 System Reference Manual

18
9. Carefully set the new I/O expansion board into the system and align all of the plastic board guides
(on the back side of the board) with the holes in the metal chassis. Proper alignment of the plastic
board guides is critical to board installation.
10. Slide the I/O expansion board to the power distribution board connectors.
11. Grasp the metal covers of the I/O expansion board connectors and squeeze the board into the
power distribution board connectors.
12. Secure the board to the chassis with the screw removed in step 7.
13. Connect the I/O cables to the I/O expansion board.
14. Replace the AC section and I/O connector board.
15. Replace the option boards and connect their cables.
16. Replace the side panel.

Processor Board (MSMT329)

This section describes how to replace the processor board MSMT329. The replacement board comes
with processors and voltage regulator modules installed by Intergraph. However, memory modules
must be swapped from the old board to the new board.
To replace the processor board:
1. Remove the left side panel. The following figure shows the processor board.