I/O Expansion Board (Msmt451) - Intergraph InterServe 8000 System Reference Manual

Hide thumbs Also See for InterServe 8000:

Table of Contents

I/O Expansion Board (MSMT451)

To replace the I/O expansion board:

Remove the right side panel. The following figure shows the I/O expansion board.

Remove and set aside the AC section and I/O connector board as described previously.

Note all option board cable connections and the slot locations for each option board.

Disconnect the cables attached to option boards and remove the option boards. Place the option

boards on a flat, antistatic surface.

Note the location of each of the I/O cables (SCSI, floppy, speaker, and so on) attached to the I/O

expansion board. Disconnect the cables.

Remove and retain the screw located near the middle of the I/O expansion board.

Using the ejectors , disengage the I/O expansion board from the power distribution board. The

ejectors are located at the top and bottom of the I/O expansion board next to the power distribution

board.

Holding the board by the edges only, remove the I/O expansion board and set it aside on a flat

antistatic surface.

I/O Expansion

Board

I/O Cables

I/O Connector

Board

Screw

AC Section

Table of Contents

Do you have a question about the InterServe 8000 and is the answer not in the manual?