Table of Contents
Advertisement
How to replace the Fuser
CAUTION:
To prevent electric shock, always turn off the printer and disconnect the power
cable from the grounded outlet before performing maintenance.
CAUTION:
Before performing any of the following procedures, read and follow the safety
instructions in your Owner's Manual.
NOTICE:
To protect the drums of the print cartridges against bright light, close the front cover within
5 minutes. If the front cover remains open for more than 5 minutes, print quality may deteriorate.
NOTE:
Remove any print jobs from the center output tray, and close the multipurpose feeder before
opening the front cover.
Dell fuser are available only through Dell. To order by phone, see your Owner's Manual.
Dell recommends Dell fuser for your printer. Dell does not provide warranty coverage for problems caused
by using accessories, parts, or components not supplied by Dell.
Removing the Used Fuser
CAUTION:
To avoid burns, do not replace the fuser immediately after printing, as the fuser
gets very hot during this process.
1.
Turn off the printer and wait for 30 minutes for the fuser to cool down before removal.
2.
Push the side button and open the front cover.
- Quick Links:
- Tray Settings
Hide quick links:
Advertisement
Table of Contents
