Table of Contents
Advertisement
f.
g.
h.
Click OK to close the Property dialog box.
NOTE:
When your operating system is earlier than Windows 2000, create settings according to the
manual of the wireless setting tool provided by your wireless device manufacturer.
For Windows Vista:
a.
Open Control Panel.
b.
Select Network and Internet.
c.
Select Network and Sharing Center.
d.
Select Connect to a network.
e.
Select the setting you send to the printer from the network items listed in Connect to a
network.
f.
Select Connect Anyway in the warning dialog box indication indicating you are entering an
unsecured area.
g.
Click Close in the dialog box after confirming the connection is a success.
Access point (Infrastructure, Fixed IP network)
1.
Ensure that the addresses of your computer and access point is in the same IP range. Match the subnet
mask and gateway addresses of your computer to the access point settings.
2.
Create new wireless settings of your computer by following the steps below.
NOTE:
If your computer provides a wireless LAN adapter tool, change the wireless settings using this
tool. Or you can change the wireless settings using the tool provided by the operating system. See the
instructions below.
For Windows XP and Windows Server 2003:
a.
Select Network Connections from Control Panel.
b.
Right-click Wireless Network Connection and select Properties.
c.
Select the Wireless Networks tab.
d.
Make sure the check box for Use Windows to configure my wireless network settings is
checked.
NOTE:
Be sure to write down the current wireless computer settings in steps d and f so that you can
restore them later.
e.
Click the Advanced button.
f.
Advertisement
Table of Contents
