Table of Contents
Advertisement
When wireless infrastructure mode is set to the printer:
Select Access point (Infrastructure) networks only and close the Advanced dialog box.
g.
Click Add to display Wireless network properties.
h.
Enter the setting that you send to the printer and click OK.
i.
Click Move up to move the setting to the top of the list.
j.
Click OK to close the Property dialog box.
For Windows Vista:
a.
Open Control Panel.
b.
Select Network and Internet.
c.
Select Network and Sharing Center.
d.
Select Connect to a network.
e.
Select the setting you send to the printer from the network items listed in Connect to a
network.
f.
Select Connect Anyway in the warning dialog box indication indicating you are entering an
unsecured area.
g.
Click Close in the dialog box after confirming the connection is a success.
11.
On the Setting-Ready Printer screen, verify that the correct IP address is assigned to the printer to
which the wireless setting is set, and then click Install.
NOTE:
If your system has any of the following operating systems:
Windows XP x64
®
Windows Server
2003 x64
Windows Vista x64
Windows Vista x86
,skip step 12 and go to step 13.
12.
If you select the I am setting up this printer on a server check box on the Select Printer screen
and also select the PostScript Driver check box on the Enter Printer Settings screen, the Adobe
Systems Inc. License Agreement screen appears. Select the I accept the terms of the license
agreement option button, and then click Install.
13.
On the Congratulations! screen, click Finish to complete the installation. A test page will be printed
with the installed printer by clicking the Print Test Page button.
Use the Dell Printer Configuration Web Tool to monitor the status of your network printer without
leaving your desk. You can view and/or change the printer configuration settings, monitor toner level, and
when it is time to order replacement consumables, just click the Dell supplies link right from your Web
Advertisement
Table of Contents
