Dell 3110 Color Laser User Manual page 149

Values:
1
IP Mode* Dual Stack
IPv4 Mode
IPv6 Mode*
IPv4 Get IP
Address
IP Address
Subnet Mask
Gateway Address
Reset
2
IPsec*
1
* Only displayed when an optional multi-protocol card is installed on the printer.
2
* Only displayed when IPsec is enabled.
3
* This mode is available only when firmware version 200705311601 or later and network (MPC) firmware
version 16.03 or later are installed. Since you cannot set IPsec in Windows Vista in this mode, use the Dell
Printer Configuration Web Tool. The Get Information from Printer function on the Options tab of the
printer driver is not available when using this mode.
Protocol
Purpose:
To enable or disable each item. The change becomes effective after the printer is turned off and then on
again.
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses IPv6 to set the IP address.
3
Automatically sets the IP address.
AutoIP*
Uses BOOTP to set the IP address.
BOOTP
Uses RARP to set the IP address.
RARP
Uses DHCP to set the IP address.
DHCP
Enables the IP address entered on the operator panel.
Panel
Sets the IP address allocated to the printer by using the keys on
the operator panel.
Sets the subnet mask.
Sets the gateway address.
Disables IPsec.