Table of Contents
Advertisement
File Server Name *
Polling Interval
NCP
Packet
Burst
Password
Confirm Password
Status Information
SLP
Active Discovery
*1 The following are illegal characters: semicolon (;), colon (:), asterisk (*), question mark (?), period (.),
comma (,), yen mark (¥), back slash (\), double quotation ("), comparison symbols (< >), brackets ([ ]),
operation symbols (+, =, or ~), pipe (|), slash (/), and space ( ).
NOTE:
The settings in the NetWare page will be valid only when NetWare or the printer is rebooted.
Click the Restart printer to apply new settings button to apply new settings.
NOTE:
An optional multi protocol card is required to display the NetWare page.
SMB
Purpose:
To configure detailed settings for SMB.
Values:
1
Specifies the file server name up to 47 alphanumeric characters.
Configure this item only when Bindery: PServer Mode is
selected.
Sets the time interval from when print data enters the print queue
until printing starts. The setting range is from 1 to 1000 seconds.
The original setting remains valid if no input is made. Configure
this item only when Bindery: PServer Mode or Directory:
PServer Mode is selected.
On
Uses NCP packet burst.
Off
Does not use NCP packet burst.
Sets the print server password up to 32 alphanumeric characters.
Configure this item only when Binary: PServer Mode or
Directory: PServer Mode is selected.
Enter the password again.
Displays the status of NetWare.
Select the check box to enable Active Discovery .
Advertisement
Table of Contents
