Program Selection; How To Select The Program No - Honeywell DCP301 User Manual

6-3

Program Selection

The program No. can be selected on the console within the range 1 to 19.

How to select the program No.

Handling Precautions
Program No.1
PROG
key
key
Program No.2
PROG
key
key
Program No.3
Program No.4
PROG
key
key
• Both already set or non-set program Nos. can be selected
• The program No. cannot be selected when selecting the program No. by exter-
nal switch input.
• The program No. cannot be selected during constant-value operation.
• Pressing does not change the program No. when values currently being
entered are displayed in the MANUAL mode.
When the controller is in the basic display state in the
program operation READY mode:
PROG
• Each press of increments the program No. The
display reverts to 1 after 19.
• Each press of decrements the program No. The
display reverts to 19 after 1.
Chapter 6. OPERATION
6-7