Pv Calibration - Honeywell DCP301 User Manual

Chapter 11. CALIBRATION

PV calibration

Gain No. select
PV zero, span
11-10
keys to show (
Scroll , , , or
key.
Press PARA key until the PROG/SEG display shows (01-01). Connect calibration
device (See Section "11-3 Set Up").
Input the gain number (See Table 11-9 and Table 11-10) by scrolling , ,
keys the upper display ( ENT key not required).
(1) PV zero adjustment
(a) Press PARA key until the PROG/SEG display shows (
(b) Adjust your calibration device to an output signal equal to the 0% range value
(See Table 11-9), the signal need to be on the input for 10 to 15 seconds.
(c) Press ENT key after display stabilizes.
(2) PV span adjustment
(a) Press PARA key until the PROG/SEG display shows (
(b) Adjust your calibration device to an output signal equal to the 100% range value
(See Table 11-9 and table 11-10).
(c) Press ENT key after display stabilizes.
Table 11-9.
Gain No. PV Input 0% PV Input 100%
0 –12.785mV
1 –8.565mV
2 –13.788mV
3 –12.000mV
4 –1.000mV
5 –0.100V
6 –0.500V
7 –1.000V
8 0.000mA
9 10.000
10 10.000
11 0.000
12 0.000
Table 11-10.
Gain No. PV Input 0% PV Input 100%
16 –8.000mV
17 –20.000mV
18 –1.000V
19 10.000
20 0.000
1.0.1.1.
) on upper display, then press ENT
Connecting Position
110.000mV Between 34(+) and 33(–)
58.303mV Between 34(+) and 33(–)
40.481mV Between 34(+) and 33(–)
23.300mV Between 34(+) and 33(–)
11.000mV Between 34(+) and 33(–)
1.100V Between 34(+) and 33(–)
5.500V Between 34(+) and 33(–)
11.000V Between 34(+) and 33(–)
22.000mA Between 34(+) and 33(–)
480.000 Between 34 and 33
178.000 Between 34 and 33
110.000 Between 34 and 33
45.000 Between 34 and 33
Connecting Position
20.000mV Between 28(+) and 29(–)
70.500mV Between 28(+) and 29(–)
11.000V Between 27(+) and 26(–)
380.000 Between 30 and 29
110.000 Between 30 and 29
, or
01-02
).
01-03
).