Setting Up G.soak (Guarantee Soak) Items; Setting Up G.soak Time-Out Items - Honeywell DCP301 User Manual

Chapter 8. PROGRAM SETUP

Setting up G.Soak (guarantee soak) items

Display

Setting up G.Soak time-out items

Display
8-10
(1) In the setting display state, move to the G.Soak item of the segment to be set up on the
programming map.
ENT
(2) If you press , the lower display starts blinking to indicate start of entry to the
No.1 setup.
(3) Press , , or
Setting range: 0 to 1000U
ENT
(4) When you press , blinking on the lower display stops.
FUNC CLR
(When + are pressed, the lower display returns to "- - - -" and blinking
stops.)
Program No. Segment No.
Pattern
tendency
EV1 to EV3 and T1 to T5 all out
• "- - - -" is displayed for the setting values in non-set segments.
The G.Soak function does not work in non-set segments.
• When setup data C 7 0 is set to 1, G.Soak items on the programming map are skipped
and not displayed.
(1) In the setting display state, move to the G.Soak time-out item of the segment to be set
up on the programming map.
ENT
(2) If you press , the lower display starts blinking to indicate start of entry to the
No.1 setup.
(3) Press , , or
Setting range: 0:00 to 99:59 (h:min/min:s)
0.0 to 599.9 (0.1s)
(Select either of h:min or min:s as the time unit is setup data C64.
":" is substituted by "." as it cannot display.)
ENT
(4) When you press , blinking on the lower display stops.
FUNC CLR
(When + are pressed, the lower display returns to "- - - -" and blinking
stops.)
Program No. Segment No.
Pattern
tendency
EV1 to EV3 and T1 to T5 all out
• "- - - -" is displayed for the setting values in non-set segments.
The G.Soak time out function does not work in non-set segments.
• When setup data C 7 0 is set to 1, G.Soak time-out items on the programming map are
skipped and not displayed.
to set to the G.Soak width setting.
G. S.
G.Soak setting value
to set to the G.Soak time-out width setting.
G. S. t O
G.Soak time -out setting value