Honeywell DCP301 User Manual page 160

Item
Event/ Events 1, 2
Time
Event
Output
Event 3
Time events 1 to 5
Event 1 to 3 settings
Time event 1 to 5 settings
Commu- Communications system
nications
Interface system
Relay contact Contact type:
output Contact rating:
Life:
Min. switching voltage, current:
Relay contact Contact type:
output
Contact rating:
Life:
Min. switching voltage, current:
Open-collector External supply voltage:
output
Max. load current:
OFF leakage current:
ON residual voltage:
Event type
PV type events:
Controller status events: RUN+HOLD+FAST+END, READY,
Time events
ON/OFF selectable
Event standby
0 to 200U (event types PV, deviation, absolute value deviation
Event hysteresis
or SP)
0.0 to 20.0% (event types MV or MFB)
0 to 3600s
Event ON delay
Time events, segment No. events
Time event type
RS-485
Communications
standard
Network Multidrop (DCP301 provided with only slave node functionality)
1 to 31 units max.
Half duplex
Data flow
Synchronization Start-stop synchronization
Balanced (differential)
Transmission
system
Data line Bit serial
5 transmit/receive lines (3-wire connection also possible)
Signal line
4800, 9600bps
Transmission speed
Transmission 500m max. (total)
distance
Conforming to RS-485
Other
Chapter 10. SPECIFICATIONS
Specification
1a
1A (240Vac/30Vdc, resistive load)
100,000 operations (at rating)
10V, 10mA
1a1b
2A (240Vac/30Vdc, resistive load)
100,000 operations (at rating)
10V, 10mA
10 to 29Vdc
70mA/load
0.1mA
1.6V max.
PV, deviation, absolute value
deviation, SP, MV, MFB
RUN, HOLD, FAST, END, G.Soak
standby, MANUAL, auto-tuning
executing, constant-value operation,
MFB estimated position control, sum
of all alarms, PV range alarm,
controller alarms, low battery voltage,
setting on console, ADV
10-5