Gerber OMEGA CP Reference Manual page 692

678 Chapter 61:
Choosing the Plotter or Printer
4 Click the slider bar under Sharp Corners and drag it to adjust the form of the corners.
5 Click Advanced to view round corners in inches or millimeters.
6 Click OK.
Adjusting the pounce tool settings
Pouncing is a technique that creates a punched outline of a graphic on paper. Pounce patterns
are used to align vinyl letters on large jobs or to chalk an outline for a job that will be hand
painted.
The tool is driven (vertically) into the paper and then moved (horizontally) to make a small rip.
The plotter controls the size of the rip (Down Percentage) and the Pattern Length to create the
pounce pattern.
In Pounce Tool Settings, choose one of three standard pounce patterns, or customize a pattern
by specifying a Pattern Length and a Down Percentage.
To adjust the pounce tool settings
1 Click Setup > Device Select to open the Plotter/Printer Select dialog box.
2 Click the Settings button to open the Plotter Settings dialog box.
3 Turn on Pounce to activate the Pounce Tool Settings group box.