Gerber OMEGA CP Reference Manual page 459

5 Use the scroll arrows to select the Outline Number to move. The Outline Distance
from the object changes as you change from one number to another.
6 Enter a new Outline Distance from the object. The graphic display does not update
unless you change Outline Number after changing the Outline Distance.
7 Click OK in the Advanced Outline dialog box.
8 Click OK in the Outline dialog box.
Moving individual outlines graphically
When moving individual outlines, the one you move is the one shown as a red bar in the
graphic display at the bottom of the Advanced Outline dialog box. The green bar represents the
edge of the object. The black bars represent other outlines. Use the following procedure to
change one or more individual outlines.
To move an individual outline graphically
1 Select the object to outline.
2 Click Tools > Outline to open the Outline dialog box.
3 Choose the Pass, Corner Type, Number of Outlines, and the Outline Distance.
4 Click Advanced to open the Advanced Outline dialog box.
5 Click Select Outline, and then click the cursor on the outline to move to select it.
6 Click Move Current Outline, then click on the selected outline, and drag it to a new
position.
7 Click OK in the Advanced Outline dialog box.
8 Click OK in the Outline dialog box.
Tip: Use the navigation buttons shown below to quickly move to the outline you have selected.
These navigation buttons are useful to assign and move many outlines.
445