Gerber OMEGA CP Reference Manual page 677

Changing the start and end position of a plotter
You can choose to return to the original start position at the end of a cut job, or to locate the
plotting tool for the start of the next job. By default, the plotter begins a job at the lower left and
ends it at the lower right.
Choose the location to start and end in the Start/End Position dialog box. The plotter end
position is indicated by a red O in the GSPPlot window. If the job is print and cut the start
choice is not available. Cutting always starts in the lower left corner, indicated by a green
registration mark.
Note: Not all plotters allow start and end positions to be changed. The controls in the
Start/End Position dialog box will be disabled for plotters that do not provide this support.
Rewinding the material after printing
Choose the left or right location in the Printer End group box to set whether or not the material
rewinds after printing. The left radio button sets the printer to rewind the material. The right
radio button does not rewind the material after printing.
When a printed job displays in the GSPPlot window, a green X indicates the Start position, and
a red indicates the End position.
To change the start and end positions
1 Click Setup > Start/End Position to open the Start/End Positions dialog box.
2 Choose a plotter start position in the Plotter Start box.
3 Choose a plotter end position in the Plotter End box.
4 Choose the location for the printer to end in the Printer End box.
5 Click OK.
Note: You can not change the plotter start and end position for a job with repeats or panels. The
plotting tool path defaults to starting in the lower left position and ending in the lower right
position of the design.
663