Gerber OMEGA CP Reference Manual page 412

398 Chapter 36:
Digitizing Artwork
1 In Composer, click on the Box tool. The cursor will now change into crosshairs with a
small box symbol in the lower right corner.
2 On the tablet position the puck over the first corner of the rectangle and digitize the
first point with button 1.
3 Move the puck to the opposite corner of the rectangle and release button 1 to digitize
the rectangle.
To digitize the left base
1 Position the puck over the point of the shape labeled with the S and digitize the first
point with button 1.
2 Move the puck to the next point and again click button 1 to digitize it.
3 Position the puck over the next point and click button 4 (F12) to Start Curve Abrupt,
then click button 1 to digitize the point.
4 At the last point of the curve segment, click button 4 (F12) to End Curve Abrupt, then
click button 1.
5 Begin the next curve with button 4 (F12), Start Curve Abrupt, and then click button 3
to digitize the point.
6 At the last point on the curve click button 4 (F12) to End Curve Abrupt.
7 Click button 3 (End) to Close Shape.
To digitize the stem
Left Base
Stem