Gerber OMEGA CP Reference Manual page 518

504 Chapter 45:
Repeating Objects – Text or Shapes
Creating a line of repeats with incremental sizing
Use the % Size Change box in the Advanced Repeats dialog box to change the size of each
repeated object. The percent is based on the size of the original object, not on the subsequent
repeated objects. A change in the X size horizontally lengthens or shortens an object. A change
in the Y size vertically lengthens or shortens an object. Negative values reduce the size of objects
and positive values increase the size. See the following illustration.
Setting the direction and alignment of the repeats
The Direction option allows you to repeat the original object in four different directions. The
Alignment option allows you to specify the alignment of the repeated object. Alignment only
applies if you increase or decrease the size of the repeated object using the X and Y % Size
Change. The Y size change allows you to justify to the top, middle or bottom of the objects. An
X size change allows you to justify to the left, center or right of the objects.
To remove the repeats, Smart Edit the repeats to open Advanced Repeats and click Repeat Off.
To create repeats with incremental spacing
1 Select an object, then click Tools > Advanced Repeats to open the Advanced Repeats
dialog box.