Changing The Start And End Position Of A Job - Gerber OMEGA CP Reference Manual

662 Chapter 60:
Conserving Vinyl and Foil
2 The PrePosition by group box displays Plotter X and Plotter Y measurement boxes.
(When positioning a paneled job, Plotter Y measurements are not available.)
3 Enter a value in the Plotter X text box that represents the number of inches that you
wish to move the starting point of the job. There is no practical limit to the X
measurement that you can enter.
4 Enter a value in the Plotter Y text box that represents the number of inches that you
wish to move the starting point of the job. The Y measurements must fall within the
cutting height of the chosen plotter. Y values beyond the limit of the cutting height are
not accepted.
5 Click Continue.
Tip: When cutting a narrow job, turn on the weed border to easily remove the job inside the weed
border. Use the remainder of the vinyl for another cut vinyl job by prepositioning the plotter
above the empty vinyl space.

Changing the start and end position of a job

The Start/End Positions dialog box specifies where the plotter tool will start and end when
cutting a job, and if the material will be rewound after the last color is printed. When setting the
start and end position of a layered job, the setting applies to all layers.
Printer end
position
)
(Red
Plotter end
position
(Red O)