Finisher - Xerox 604P18228 Quick Reference Manual

Check that the Touch Screen is displaying the correct size for the paper in use.
Load fresh paper.
Repeated Check Tray Messages on the Touch Screen
and the paper is loaded in the tray
Adjust the edge guides against the stack of paper in the tray.
If the edge guides were not set against the paper stock in the tray when Start
was selected, delete the job in the job queue and begin again.
Paper Curls
Load the paper in the paper trays with the seam side of the paper up. Load the
paper in the Bypass Tray with the seam side down.
Load non-standard media in the Bypass Tray.
If the paper curls excessively, flip the paper over in the applicable paper tray.

Finisher

The Finisher does not stack the output correctly
Unload the finisher tray frequently.
Do not remove stapled sets while the finisher is compiling.
Check the paper tray guides are locked into position against the paper.
When using large paper, remove any output contained in the Stacker Tray.
Load the paper in the paper trays with the seam side of the paper up. Load the
paper in the Bypass Tray with the seam side down.
Load non-standard media in the Bypass Tray.
If the paper curls excessively, flip the paper over in the applicable paper tray.
Check the correct paper size has been selected for the paper loaded in the tray.
The Finisher does not staple or hole drill correctly
To correct stapling problems, use less than 50 sheets of paper if the paper is
heavier than 20lb.
Quick Reference Guide
The seam refers to the side of a ream of
paper with a split in the wrapping. It may
also be referred to as arrow side first.
The seam refers to the side of a ream of
paper with a split in the wrapping. It may
also be referred to as arrow side first.
Page 12-7